cadekat

joined 1 year ago
[–] [email protected] 5 points 1 day ago (1 children)

I run Gentoo as my main distro, and have for a couple years now. It's a pretty stable rolling release (IMO more stable than Arch), and since you're already an advanced user, the experience should be pretty rewarding!

The wiki is great, and the installation handbook is top notch.

You get to control exactly what features each package is compiled with, so no bloat at all.

KDE 6 just landed too!

[–] [email protected] 6 points 1 week ago

Shit, that's where my sex drive went. Can I have it back please?

[–] [email protected] 15 points 1 week ago

That's a ridiculous rationale. If the Lemmy developers actually cared about the integrity of users' posts, they wouldn't have released software without support for cryptographic signing.

[–] [email protected] 22 points 1 week ago

The missing word is "boob", for the record.

[–] [email protected] 15 points 2 weeks ago (1 children)

Bah, real power users only need a magnet and a pin.

[–] [email protected] 7 points 2 weeks ago

Linux is whatever the Linux Mark Institute says it is.

[–] [email protected] 7 points 2 weeks ago

You don't need reproducible builds. You can get by if you trust whoever compiled it, like your distro's maintainers or the pidgin developers.

[–] [email protected] 7 points 3 weeks ago
[–] [email protected] 3 points 3 weeks ago (1 children)

The risk of mis-ordering your layers is a security issue.

[–] [email protected] 9 points 3 weeks ago (5 children)

There are two ways to layer a VPN and tor:

  1. Tor over VPN; or
  2. VPN over Tor.

In the first option, you gain little. Tor already encrypts your traffic, so your ISP can't see inside them. Technically, Tor over a VPN hides the fact that you're using Tor from your ISP, but Tor's snowflake does something similar if you need that.

In the second option, you're revealing your VPN account information, which could theoretically be associated back to you. Tor adds nothing over just a VPN in this case.

[–] [email protected] 13 points 3 weeks ago (9 children)

Don't mix tor plus VPN.

If you're using tor browser without tor for some reason, carry on.

 
41
Mask of Human Rule (artlogic-res.cloudinary.com)
 
 
 
 

Hey !prusa, maybe you can help me. I have a self-assembled Mk3s+ that I put together about a year ago, but never really used because of the following problem.

If I print on draft quality, it makes it through most prints. I've printed a dozen cubes, several brackets, and some other odds and ends.

If I try to print on higher detail settings, however, it behaves very strangely. Most often it'll just hang, and keep oozing out more plastic. Once in a while, the steppers will keep turning and ram the bed or print head against the ends of their tracks.

I've tried updating and downgrading the firmware, different SD cards, etc. to no avail. Support hasn't been much help either.

Any ideas?

view more: next ›